|Part No.||D||L||d||Dp||Lp||EN 50411-3-3|
D – Outer diameter after recovery
L – Length after recovery
d – Hole diameter before recovery
Dp – Pin diameter
Lp – Pin length
XX – Color
S1 – Heat shrink single fiber
A – Primary coated 250µm(fiber) or secondary coated 900µm (buffer)
XX6 – Color according to EN 50411-3-3
The product is covered by the VIPro Loyalty Program.
For each ordered package of 1000 pcs you get 5 VIPro points.
XX – color description – XX6
00 – transparent – 00
01 – black – 10
02 – brown- 11
03 – red – 03
04 – orange – 07
05 – yellow – 02
06 – green – 05
07 – blue – 01
08 – purple – 06
09 – grey – 08
10 – wihte – 04
11 – pink – 12
12 – turquoise – 09
51 – black
52 – brown
53 – red
54 – orange
55 – yellow
56 – green
57 – blue
58 – purple
59 – grey
61 – pink
62 – turquoise
Other colors are available on request.
V24-45-00(100) – 100pcs packed to one zip-bag (Standard packing)
V24-45-00(50) – 50pcs packed to one zip-bag
* Other packing method are available on request.
The carton contains 1000 pcs fiber optic splice protectors. Standard packing consists of 10 zip bags with 100pcs of protectors each.
Other packaging methods are available on request.
V24 HARD series sleeves are applied in nearly all branches optic fibers engineering. They are used to secure connections in fiber optic splice closures as well as 19″ rack fiber optical distribution panels, stand and wall box. Stiffness of connection and quickness of assembly are the main advantages of this solution. Excellent climatic and thermal properties make it ideal for use in closed as well as open spaces. The main goals during design phase were: full protection of the fiber optic splices, stiffness of connection and short assembly time. Initial shrinking of the shield was taken into account during the production process to reduce the gap between the shields. This protects the internal tube and Pin from falling out as well as facilitates entering the optical fiber to hole. The final product is checked to meet the requirements set by the EN 50411-3-3 European Standard and GR-1380-CORE American Standard and ZN-96TPSA-006 standard of Polish Telecommunications. The sleeves we produce offer full protection to the fiber optic splices. They do not cause additional insert losses, and they offer protection against mechanical damage, pollution and weather conditions.
V24 series is characterized by stiffness of fusion, relatively small external diameter (D=2.4mm after shrinking), reduced length (the shortest L=20mm), quickness of assembly (below 60s). The sleeve consists of a 1mm diameter PIN, a thin external tube and an internal tube with a 1.2mm hole. The protectors is dedicated to primary coated 250µm (fiber) or secondary coated 900µm (buffer). The internal tube is made from special material with good adhesion to many materials and low solubility in water. It changes its consistency to semi-liquid in growth temperatures. It enables to eliminate air bubbles through filling up the spaces between the external tube, the Pin and fiber optic cable. The Pin that stiffens the splice is made from steel with a heat extensibility indicator identical to that of an optical fiber. This prevents from longitudinal stresses on the splice during heating process. Longitudinal stresses of the splice influence on growth an insert loss and a reflection loss. In extreme cases they may cause breaking the connection, which makes it necessary to repeat the splice procedure. External tube material guarantees sustainability and resistance to stretching and puncture. It offers optimal air permeability, high gloss and smooth surface.
* – Tolerances in accordance with the requirements of EN 50411-3-3
European standard EN 50411-3-3